Minimally or Less Invasive Total Knee Arthroplasty

Total knee replacement is a very successful surgical treatment for knee arthritis. Over the years, knee replacement surgery can be done through minimally invasive approach which involves much smaller incisions than the usual 10-12-inch incisions used in the traditional knee replacement.

The smaller incisions with minimally invasive surgery means that less tissues are cut resulting in quicker healing and recovery. The potential advantages of minimally invasive joint replacement surgery are:

  • Minimal surgical dissection
  • Shorter recovery period
  • Shorter hospital stay
  • Reduced postoperative pain

Minimally invasive surgery for knee replacement involves use of smaller incisions which are only 4 to 6 inches in length as compared to the 10-12-inch-long incision used in the traditional procedure.

Surgery is performed under sterile conditions in the operating theatre under spinal or general anaesthesia. You will be lying down on your back on the operating table and a tourniquet is applied to your upper thigh to reduce blood loss. Then your surgeon makes an incision along the affected knee to expose the knee joint.

The surgeon first focuses on the femur (thighbone). The damaged portions of the femur are cut at the appropriate angles using specialised jigs. Then the femoral component is attached to the end of the femur with or without bone cement.

The next step involves removal of the damaged area of the tibia (shinbone) and the cartilage. It allows for a smooth surface to which implants can be attached. The tibial component is then secured to the end of the bone using bone cement or screws.

Your surgeon will place a plastic piece called an articular surface between these implants to ensure a smooth gliding movement. This plastic insert acts in a similar way as the original articular cartilage and helps in supporting your body weight as well as allows the femur bone to move over the tibia. The femur and the tibia bone with their new components are put together to form the new knee joint.

To ensure that the patella (knee cap) glides smoothly over the new artificial knee, its rear surface is prepared to receive a plastic component.

With all its new components in place, the knee joint is examined through its range of motion.

All excess cement will be removed, and the entire joint will be irrigated or cleaned out with a sterile saline solution. The incision is then carefully closed, and drains are usually inserted. Then a surgical dressing or bandage is placed.

  • Australian Orthopaedic Association
  • Australian Knee Society
  • Arthroplasty Society of Australia
  • International Society of Arthroscopy, Knee Surgery and Orthopaedic Sports Medicine
  • Asia Pacific Orthopaedic Association
  • ESSKA
  • Australian Institute for Musculoskeletal Science
  • Royal Australasian College of Surgeons
  • Warringal Private Hospital
  • Asia Pacific Orthopaedic Association